b114 general specifcations electrical capacity resistive load: 10a @ 125v ac or 6a @ 250v ac motor load: 400w @ 125v ac lamp load: 2a @ 125 v ac for on-off-on circuit & 3a @ 125v ac for other circuits other ratings contact resistance: 10 milliohms maximum insulation resistance: 1,000 megohms minimum @ 500v dc dielectric strength: 2,000v ac minimum between contacts for 1 minute minimum; 4,000v ac minimum between contacts & case for 1 minute minimum mechanical life: 50,000 operations minimum electrical life: 25,000 operations minimum angle of throw: 25 materials & finishes frame: stainless steel case/base: diallyl phthalate resin (ul94v-0) movable contacts: silver alloy with silver plating stationary contacts: pure silver with silver plating terminals: copper with silver plating environmental data operating temp range: C10c through +85c (+14f through +185f) humidity: 90 ~ 95% humidity for 96 hours @ 40c (104f) vibration: 10 ~ 55hz with peak-to-peak amplitude of 1.5mm traversing the frequency range & returning in 1 minute; 3 right angled directions for 2 hours shock: 50g (490m/s 2 ) acceleration (tested in 6 right angled directions, with 5 shocks in each direction) installation soldering time & temp: wave soldering (straight pc): see profle a in supplement section. manual soldering: see profle a in supplement section. cleaning: these devices are not process sealed. hand clean locally using alcohol based solution. standards & certifications flammability standards: ul94v-0 rated case/base ul: file no. e44145 - recognized only when ordered with marking on switch. add /u before dash in part number to order ul recognized switch . add /cul before dash in part number to order culus recognized switch . all models recognized at 10a @ 125v ac & 6a @ 250v ac. csa: file no. 023535_0_000 - certifed only when ordered with marking on switch. add /c before dash in part number to order csa certifed switch . all models certifed at 10a @ 125v ac & 6a @ 250v ac. vde: license no. 119174 all models approved at 10a @ 125v ac & 6a @ 250v ac. marking on switch is standard. all models meet en 61058-1 standard. series p internationally approved rockers/paddles indicators accessories supplement tactiles keylocks rotaries pushbuttons illuminated pb slides programmable b rockers touch tilt toggles www.nkkswitches.com
b115 distinctive characteristics meets en 61058-1 standard. contacts of special silver alloy resist arcing and guarantee stable electrical contact and long life. stainless steel frame resists corrosion and increases environmental safety. high insulating barriers increase isolation of circuits in double pole devices and provide added protection to contact points. case/base of heat resistant resin meets ul94v-0 fammability standard. prominent external insulating barriers increase insulation resistance and dielectric strength. clinching of the frame to the case well above the base and terminals provides 4,000v dielectric strength. epoxy sealed terminals prevent entry of fux, solvents, and other contaminants. actual size series p internationally approved rockers/paddles indicators accessories supplement tactiles keylocks rotaries pushbuttons illuminated pb slides programmable toggles b rockers touch tilt www.nkkswitches.com
b116 terminals no code solder lug p straight pc z .187 (4.75mm) quick connect typical switch ordering example c p20 dpdt on-none-on circuit poles & circuits 11 spst on none off 12 spdt on none on 13 spdt on off on 21 dpst on none off 22 dpdt on none on 23 dpdt on off on rocker/paddle caps for n frame d .365 (9.27mm) wide rocker e .365 (9.27mm) wide paddle for y frame j .595 (15.11mm) wide rocker h .595 (15.11mm) wide paddle description for typical ordering example p2022y-jc frame for large caps solder lug terminals cap colors a black b white c red e yellow f green g blue h gray paddle/rocker frames n frame for small caps y frame for large caps y j .595 (15.11mm) wide red rocker 22 important: vde is marked on all models. switches are supplied without ul, culus & csa marking unless specifed. ul, culus & csa recognized only when ordered with marking on the switch. specifc models, ratings, & ordering instructions are noted on general specifcations page. series p internationally approved rockers/paddles indicators accessories supplement tactiles keylocks rotaries pushbuttons illuminated pb slides programmable b rockers touch tilt toggles www.nkkswitches.com
b117 (7.6) .299 (1.17) .046 thk = (1.0) .039 epoxy seal (4.8) .189 rocker/paddle frames n frame for small actuator frame for large actuator y terminals solder lug z p no code .187 (4.75mm) quick connect straight pc using at4148 & at4149 rocker position connected terminals throw & schematics pole model down center up down center up note: terminal numbers are on the switch. sp p2011 on none off 1-1b open open spst sp p2012 p2013 on on none off on on 1-1b open 1-1a spdt dp p2021 on none off 1-1b 2-2b open open dpst dp p2022 p2023 on on none off on on 1-1b 2-2b open 1-1a 2-2a dpdt poles & circuits 1 (com) 1b 1 (com) 1b 1a 1 2 (com) 1b 2b 1 1b 2b 2 (com) 1a 2a (28.5) 1.122 (34.9) 1.374 (16.0) .630 (3.5) dia ty p .138 (10.1) .398 (17.8) .701 (34.9) 1.374 (3.5) dia ty p .138 (12.8) .504 (34.9) 1.374 (41.3) 1.626 (3.2) dia ty p .126 (6.0) .236 (13.5) .531 (12.8) .504 (34.9) 1.374 (41.3) 1.626 (3.2) dia ty p .126 using at4156 & at4157 spdt (1.8) dia ty p .071 (7.62) ty p .300 1 1a 1b spst (1.8) dia ty p .071 (7.62) ty p .300 1 1b dpdt (10.16) .400 (1.8) dia ty p .071 (7.62) ty p .300 1 1a 2a 2 1b 2b maximum panel thickness: .126 (3.2mm) maximum panel thickness: .126 (3.2mm) (6.35) .250 (1.3) dia .051 (4.75) .187 (9.0) .354 thk = (0.8) .031 rocker/paddle frames terminals epoxy seal (4.5) .177 (2.6) .102 (1.25) .049 (2.0) .079 thk = (1.0) .039 dpst (10.16) .400 (1.8) dia ty p .071 (7.62) ty p .300 1 2 1b 2b series p internationally approved rockers/paddles indicators accessories supplement tactiles keylocks rotaries pushbuttons illuminated pb slides programmable toggles b rockers touch tilt www.nkkswitches.com
b118 typical switch dimensions p2012n-dc p2011 & p2021 models do not have terminals 1a & 2a. y frame n frame p2022y-jc p2011 & p2021 models do not have terminals 1a & 2a. rocker/paddle caps d at4148 .365 (9.27mm) wide rocker at4149 .365 (9.27mm) wide paddle e for n frame for y frame j at4156 .595 (15.11mm) wide rocker at4157 .595 (15.11mm) wide paddle h a black cap colors available: b white c red e yellow f green g blue h gray material: polyamide finish: matte 1b 1a 1 (20.5) .807 (3.2) dia ty p .126 (2.6) .102 (11.0) .433 25 (12.3) .484 (0.6) .024 (1.25) x (2.0) ty p .049 x .079 (1.0) ty p .039 (0.8) .031 (7.62) .300 (0.5) .020 (5.0) .197 (3.5) .138 (9.65) .380 (22.0) .866 (12.8) .504 (34.9) 1.374 (41.3) 1.626 (13.5) .531 (9.27) .365 (15.11) .595 (12.8) .504 (34.9) 1.37 4 (41.3) 1.626 (3.2) dia ty p .126 25 (14.5) .571 (0.6) .024 (1.25) x (2.0) ty p .049 x .079 (1.0) ty p .039 (0.8) .031 (7.62) .300 (0.5) .020 (3.5) .138 (5.0) .197 (21.7) .854 (10.1) .398 1 2 2a 1a 1b 2b (20.0) .787 (10.16) .400 (20.5) .807 (2.6) ty p .102 (6.15) .242 (7.9) .311 (8.8) .346 (3.5) .138 (13.49) .531 (16.87) .664 (9.27) .365 (9.27) .365 (18.8) .740 (2.13) .084 (3.96) .156 (8.43) r .332 (3.5) .138 (16.8) .661 (15.11) .595 (11.0) .433 (26.78) 1.054 (23.01) .906 (10.11) .398 (6.6) .260 (3.5) .138 (14.33) .564 (15.11) .595 (29.82) 1.174 (26.8) 1.055 (2.36) .093 (4.75) .187 (13.5) r .531 (7.3) .287 (3.5) .138 series p internationally approved rockers/paddles indicators accessories supplement tactiles keylocks rotaries pushbuttons illuminated pb slides programmable b rockers touch tilt toggles www.nkkswitches.com
|
